Monday, April 15, 2013
VAUXHALL/OPEL CORSA installation instructions
VAUXHALL/OPEL CORSA 1.2, 1.4 Spi 60BHP 1993-99 57-0298 sheet A2054-786, page 1 of 2 Please read the instructions carefully before installing the Kit. Note: the kit is suitable for both models. Figure A figure B 1. Unclip and remove the intake hose from the Air box Assembly. 2. remove the box of hot air valve vacuum hose behind the intake housing. Empty out the vacuum secondary side outlet with rubber sealed with the supplied stopper. 3. Unclip and remove the intake scoop in front of the cross-member and the air box Assembly. 4. disconnect between the exhaust manifold and the air conditioning box hot air flap the flexi-hose. 5. remove the Air box Assembly from the front and push the installation the installation of the rubber grommets in the back. Disconnect the car. 1. install a new mounting bracket on the back of the original, without the box mounting grommet
using large washers, spring washer, flat washer, nut and screw provided in the Kit. 2. install the metal tube up to step the filter base. Push it step affects the airflow. Tighten the filter in the filter until the clip just studded the changes. 3. Fit the filter intake hose assembly and tighten firmly with the new clip. 4. attach the clip to the new clip studded with using a flat washer, spring washer and nut that has been delivered. 5. turn the filter so that the K & 's logo is directly related to tighten the clip with one turn (360 degrees) would no longer be, tighten the clip. 6. Carefully lengthen the flexi Cold Air hose is approx 64 cm/25 ". Feed the hose down to the lower plastic trim between the next to the radiator grille. Connect the hose to the flexi cold air hose to the top of the top of the coolant, using a long plastic tie. Flexi-cold air conditioning hose, so that it is in the filter and the position of the 10 cm/4 "off the closer. The car and the engine bay should look like in these photos, they are, if not ...
No comments:
Post a Comment