Monday, April 15, 2013
Toyota 2 l-T, 3 l engine repair manual supplement
This guide will help you find your way through the part of the title and an outline of the main headings given at the top of every page. The INDEX is given in each section to guide you to the correct destination on page 1. The precautions at the beginning of each chapter is given relating to any fixes for that paragraph. Please read these precautions before any repair to be made. The TROUBLESHOOTING tables are included in each system can help you determine the problem and find the cause. Each possible cause correction refers to medicine-column quickly lead to a solution.
How to use the Guide
Procedures are presented in a step-by-step format: #
• Example shows, what to do and when to do it.
• Task title tells you what todo.
• Detailed text explains how to complete the task and provide other information such as technical specifications and warnings.
This format provides a knowledgeable technician quickly with the necessary information. The big task title can be read at a glance, if necessary, and below that the text contains detailed information. Technical specifications and warnings always stands out in bold type.
GENERAL REPAIR HELP
1. use a fender of the vehicle seat and the floor covers to keep clean and prevent damage.
2. in order to facilitate the dismantling, the parts of the Assembly during the keep.
3. Please observe the following.
(a) before performing electrical work, disconnect the negative cable from the battery to the belly button (—).
(b) if it is to disconnect the battery to check or repair, always disconnect the cable from the negative (-) terminal that is grounded to the vehicle's chassis.
(c) to prevent damage to the battery terminal post on the loos-en in the Terminal nut and lift the cable straight up without twisting or prying on it.
(d) end of the battery posts and cable terminals, clean shop rag. Do not scrape them with a file or other abrasive objects.
(e) Install the terminal cable from the battery post is loose, and tighten the nut after installation. Use a hammer to tap the neliönmuotoiseen terminal. (f) be sure the lid of the positive (+) Terminal is properly in place.
4. check hose and cable connections to make sure they are in good condition and correctly.
5. non-reusable components
(a) always replace the Cotter, gaskets, O-rings, oil seals, etc.
(b) non-reusable components are marked as part of the "?" entry.
No comments:
Post a Comment