Monday, April 15, 2013
Mitsubishi Lancer QuickLIFT installation guide
Removes all items from the packing tube. You should be, first of all, as follows:
* (2) gas springs (RT-QL-170-A6A) – be sure to cycle through them a few times before installation.
* (4) # 2-3/16 Multi grip rivets (used in the hood are given in brackets)
* (2) ball studs and washers, Central locking nut.
* (2) mounting brackets
* Printed colour instructions
* The gas spring to the central locking clips (already installed gas spring ball-ends to remove before installing)
Before you start installation, collect the following tools:
* Power drill
* 3/16, indexed by # 11 & 5/16 drill bits
* Great perm or felt pen
* A tape measure or ruler
* Masking Tape
* Hammer & center punch
* The rivet gun, may be 3/16 rivets (most manufacturers can handle this size)
Note: use only lShetettiin QuickLIFT system rivets.
A. open and prop the hood.
B. on the driver's side in the middle of the engine compartment, the stands are examined range from the inner fender lip.
Note the overhanging fender mounting bolt. The central line hit the Flash should be used to align the ball stud bracket (3/8 "offset to the left or to the front of the vehicle). In the back of the bracket against the lip.
(C) either on a flat rack the rack to align the Insert the left edge of the metal below, or use the measuring point, the right (centerline to replace the 3/8 ").
No comments:
Post a Comment