Monday, April 15, 2013
OPEL Zafira moottorin siirto asennusohje
ZF Trading GmbH Obere Weiden 12 97424 Schweinfurt Germany © ZF Trading GmbH 0032004_OSOPE019 OPEL Zafira engine to another, removing and installing/replacing the manual transmission. To remove: lift the vehicle. Remove the lower engine cover. Descend in front of the exhaust pipe to remove the catalytic converter. In the Centre of the foot against muffler. Remove the water tank cover. Remove the water tank insulation. (see Figure 1) Align the motor/gearbox unit with Transmission equipment. Remove the front axle is steering wheel to take part in the straight. Screw on the clamping joint. Remove the spindle. (see Figure 2) Remove the battery. Remove the battery holder. Vehicles with gasoline engine disconnect the lambda sensor connector. (see Figure 3) Secure the radiator see fig. 2 1 tightening the joint to fall against. Lambda sensor connector fig. 3 1. Figure 4 in 1 thread. Does. Using the number of the footnote (1) of the motor parts engine transmission support MKM-833-1-2 switch. MKM-883-2 3 farm equipment B/909/miles 4 KM-Holding devices, 6001-A switch 1 the tool KM-652 2 centering mandrel KM-734 F17 gearbox 3
Centering mandrel KM-735 F23 gearbox required special tools: image 1 1 fixing bolt (s) means the thread. (see Figure 4) Disconnect positive junction. Remove the fuse. Remove the bracket. Disconnect the earth cable. Disconnect the connector (s). (d) Attach retaining plate and hang the motor bridge. Installation instruction switch shock absorber page 2 installation instructions – remove the wheel housing covers OPEL Zafira. Remove the front panels. Rotate the pendulum supports. (see Fig. 6), Rotate the track rod joints and eliminate them using a lever to Unclip, guiding the joint. (See materials by squeezing) Remove the Exchange connection. (see the extruding machine) Rotate Takamoottori the damping prevents the holder from the transmission. (see Fig. 9), disconnect the engine from the front axle to prevent the damping of the body. (see Fig. 10) remove the mounting bolt (s). Carefully on the front axle of the lower body. (see Fig. 11) disconnect the transmission. Remove the air cleaner housing. Remove the cleaner to intake air hose. Remove the right engine of the attenuation of the block. (see Fig. 12) on the top of the brake fluid tank to the "up to". Disconnect the pressure line connecting piece with concentric slave cylinder in the clutch housing. Disconnect the electrical connector. (View menu) Disconnect the left engine block replacement. (see Fig. 14) to lower the engine/transmission unit a little, by way of derogation from the support Bar of the spindle. Remove the axle shafts. (see Fig. 15) to disconnect the transmission shift cables. (see Fig. 16) remove the attenuation of the block of the engine. (see Fig. 16) the Unbolt the motor/gearbox.
No comments:
Post a Comment